Before & After Gallery - Brandt HVAC Co Ventura

HVAC Before & After in Ventura, CA

Talk is cheap in this trade. We can tell you all day that we clean up after ourselves and write honest prices, but you shouldn’t have to take our word for it. Here’s what actually happens when we show up: the crusted-over condenser coil, the furnace cabinet with the original 1999 filter, the duct collar that was held together with tape and hope. Then what it looks like when the work is done right. These are real job scenarios from Ventura County homes, written by Devin Marlowe, Owner at Brandt HVAC Co Ventura.

Call (831) 539-0291

Recent Transformations

Seized AC Condenser Fan Motor Replacement in Midtown Ventura

BeforeAfter

The condenser was humming but the fan wasn’t turning. That’s the classic sign of a dead run capacitor taking the fan motor down with it. We found the motor windings open and the capacitor bulged at the top, which means the compressor was next in line if this kept running. We replaced the motor, capacitor, and contactor as a set, and wrote the repair up with a 365-day guarantee before any work started. Total time on site: just over two hours.

Furnace Igniter and Flame Sensor Replacement Near Ventura College

BeforeAfter

The furnace would click on, run the draft inducer, and then shut down without ever lighting. On a 2008 Goodman, that pattern points straight at the igniter, and sure enough, the silicon nitride element had a hairline crack right through the middle. We replaced the igniter, cleaned the flame sensor with a proper abrasive pad rather than the emery cloth hack that ruins them, and verified the whole ignition sequence three times before we packed up. Most igniter replacements in Ventura run $150 to $300 with parts and labor included, and this one landed right in that range.

Full AC System Tune-Up and Coil Cleaning in East Ventura

BeforeAfter

This evaporator coil hadn’t been opened since it was installed, and it looked like someone had glued a felt blanket to the face of it. The homeowner said the system ran constantly and never quite cooled the back bedrooms. We pulled the coil, cleaned it with a proper foaming agent and rinse, cleared the drain line with nitrogen, and checked the charge. Temperature split went from 11 degrees to 19. That’s the difference between a system that struggles and one that works, and it’s exactly what an AC maintenance visit at Brandt HVAC is supposed to catch.

Condenser Coil Chemical Clean on a Dusty Ranch-Style Home in Saticoy

This Rheem condenser sat next to an unpaved driveway, and every dry Santa Ana wind loaded the fins with dust until you couldn’t see daylight through them. High head pressure had the compressor running hot, and the system was tripping the high-limit on warm afternoons. We chemically cleaned the coil, combed out the worst of the fin damage, and brought the head pressure back down to where the manufacturer says it belongs. The unit’s running quiet now, and the compressor isn’t cooking itself.

Thermostat Rewiring and Short-Cycling Fix in the Ventura Hillsides

The AC would kick on for 45 seconds, shut off, wait, and do it again. The owner thought the thermostat was bad and had already bought a replacement. We opened the air handler and found the real problem: a thermostat wire that had rubbed against a sheet metal edge for years until it finally wore through the jacket. Every vibration from the blower caused a short, and the board reset. We reran the low-voltage wiring, secured it properly, and left the owner’s new thermostat in the box with a suggestion to return it for a refund. That kind of fix costs less than a service call fee and saves a lot of frustration.

Furnace Airflow Correction and Duct Sealing in a 1960s Ventura Bungalow

The furnace ran beautifully, but the hallway register barely moved a tissue while the master bedroom stayed cold all winter. Under the house, a duct collar had separated from the main trunk, so half the heated air was conditioning the dirt floor. This is the stuff that happens in older Ventura homes, especially after a light earthquake shakes everything loose. We reconnected the collar, sealed the joints with mastic rather than duct tape, and strapped the flex runs properly. Now the airflow actually reaches the rooms it’s supposed to, and the crawlspace stays the crawlspace’s temperature.

Want Results Like These?

Every job starts with a written price before we touch a single tool, and every repair carries the 365-Day Done Right Promise. If it fails within a year, we come back free. No argument. Call Brandt HVAC Co Ventura at (831) 539-0291 and a live person answers, day or night. We’ll send a tech you know by name before they knock.

Written by Devin Marlowe, Owner at Brandt HVAC Co Ventura.